Junior Banger Rules
There have been one or two issues raised at scrutineering, Some of the main problems are highlighted below.....
13. ENGINES
1. The engine must remain as it was produced in its standard form.
2. The air filter may be removed or replaced.
3. Only the 34 ICH Weber carburettor may be used to replace the standard carburettor for the
model of car being raced.
4. No modification to the carburettor allowed.
5. Multi point injection can be used, but you may also remove the injection system and replace it
with the previous carburettor set up or Diesel.
6. Any alteration or removal of engine numbers will deem the engine illegal.
Engine / Gearbox Mounts
1. Alloy engine/gearbox mounts can be replaced by fabricated steel versions and welded or
bolted to the chassis. The maximum size of the mount is 5 inches where it is attached to the
chassis. The mount must not exceed the original size of the standard mount which is being
replaced, it is solely for holding the engine in and not for strengthening, and no part of the
mount must be in front of the engine.
Bonnet Fixings
1. Bonnet bolts cannot be used. Bonnets must be secured by seatbelt only with a maximum of 4
ties.
Triangular corner plates or straps may be used to secure the rear of the bonnet by bolting or
welding (1/8”thick). Plates or straps must be placed no further than 12” across or down from
the back edge and side of the bonnet. In this case you may only use two seatbelt fixings at the
front.
15. WHEELS & TYRES
1. All four wheels must be of the same diameter.
2. All wheel fixings must be in place.
3. All wheel weights & hub caps must be removed
4. Any standard road wheel steel or alloy can be used up to a width of 6”.
5. No Weller rims permitted.
6. Only conventional tyres may be used with a maximum tread depth of 6mm. Tyres must read <60 on a durometer at any time.
7. Tyre Gaiters are permitted.
8. You are not allowed to use the following:
Racing tyres. Mud & Snow tyres, Alpine tyres, knobbly or any type of competition tyre, Town &
Country tyres, 7.3 Avon Turbo Speeds, Yokohamas, Colway Competition tyres, Goodyear F1
Eagle, Tread cut tyres, Tyre with the markings erased or National Bangers remould tyres.
Decisions on which tyres are permitted will be at Scrutineer’s discretion.
There is a FULL set of rules on Trackstar website and the Spedeworth website, or contact Trackstar office for a copy.